favorite
favorite
hide
unhide
flag

Posted

print

Ford 9" Tubber - $2,000 (Berea, ky.)

Ford 9" Tubber 1 thumbnailFord 9" Tubber 2 thumbnailFord 9" Tubber 3 thumbnailFord 9" Tubber 4 thumbnail
condition: like new
make / manufacturer: Ford
Ford 9" rear end narrowed for 1982 to 1993 V8 powered S10 truck or Blazier

* Heavy stamped housing with 3" axle tubes with big ford 3.15" OD flanges
* Center section has been centered up to prevent U-bolt walkup, left axle is 17 5/16" long and right axle is 19 3/16" long
* New JEGS 2 1/2" X 5" axle tube perches welded on at 3.5 degrees
* Perches mounted at 19.25" center hole to center hole, drum face to drum face is 39" frame rails need to be 20 1/2" apart
* Rear end is set up for 18.5" X 15" M/T sportsman tires with 4 1/2" to 5 1/2" set back on 15" rims
* 2.891" stock 9" carrier bearings with JEGS 31 spline mini spool (direct drive)
* 8.8" (8 3/4") ring and pinion with 3.70:1 gear with large 3 5/8" stock ford yoke
* 1 5/8" drive line U-bolts (not included)
* Bastard joints from Ford to GM are available (not included) Drive shaft must be re-tubed to desired length
* Big ford 1 1/2" 31 spline axles re-splined by Moser Eng.
* Big ford 1.530" roller bearings with new inner flange seals, 2 3/8" X 3 1/2" flanges with 1/2" T-bolts
* Axles flanges have been drilled and tapped to the 4 3/4" small chevy pattern with 2" X 1/2" X 20 Moser lug studs
* New big 11" drums also drilled to the 4 3/4" chevy pattern with new 11" X 2 1/4" brake shoes
* New steel brake backing plate flange gaskets, new wheel cylinders and new wheel cylinder links
* New brake hardware and spring kits, new emergency brake cables
* New standard 3/16" brake lines and fittings, new union block with new rubber connecting hose
* New housing clear vent tube with new brass vent filter
* Topped off with 2 quarts of fresh Valvoline 90 weight gear oil

* Lee Morris
* show contact info
* Berea, Kentucky 40403

post id: 7744669780

posted:

updated:

best of [?]

loading
reading
writing
saving
searching